Model UT60H: OPERATING MANUAL
19
Measurement Operation(5)
Note
l If the value to be measured is unknown, use the
maximum measurement position and reduce the
range step by step until a satisfactory reading is
obtained.
l When the measured current is 5A, continuous
measurement is allowed.
l When the measured current is between 5A-10A,
continuous measurement 10 seconds and interval
more than 15 minutes.
l When AC current measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test and remove testing leads
away from the input terminals of the Meter.
To Next Page
Loading...
