- 23 -
10.3 INSUFFICIENT OR NO HEATING PROCESS
- After getting a few cups of coffee, the machine gets "cold".
- Check the infusion time and adjust the grind accordingly.
- Make sure that each pin of the heating element works.
10.4 IMPOSSIBLE PROGRAMING
IMPOSSIBLE PROGRAMING
Check the configuration of the box
A0 : Prohibited programing
A1 : Authorized programing
See on pages 28 and 29
Display of one safety signal
P1 to P5 : Safety key
F- : Fuse
t : Time
co/cc : Dosing device
Refer to the corresponding
paragraph to repair
To Next Page
Loading...
