Unical ALKON 50 c - Programming Operation Parameters

35
ENGLISH
Installation Instructions
4.4 - PROGRAMMING OF THE OPERATION PARAMETERS
ATTENTION!
Function reserved for Authorised Assistance
Centres only.
The user is NOT authorised to activate the
function described below.
SE SERVICE PARAMETER
Press the YELLOW key and the LIGHT BLUE key simulta-
neously to enter in the service mode SE and change value.
A Operation READING PARAMETER
Press the YELLOW key to view default setting
B Operazion CHANGE PARAMETER
Press key + (PLUS) / - (MINUS) to modify
C Operazion SET MODIFY PARAMETER
Press the YELLOW key
BURNER MODULATION LEVEL IN IGNITION
Continue with the modication of parameters by pressing
the (MINUS)
Repeat the operations A-B-C to change value
VALUE
FROM TO DEFAULT
ALKON34,5-50c ALKON 70 c
0 99 Methane 40 50
0 99 Propane 45 60