8
Initial Clock Set-up
1. When power is initially applied, the LCD
display flashes 12:00 P after a short delay.
2. Enter the correct time using the
numeric key or s/t keys.
3. Press
AM/PM
Key to toggle to desired setting,
either AM or PM.
4. Press
E
Key to complete the entry.
After scanner has been turned on, to reset the clock simply press and hold the
TIME SET
key. The LCD display flashes the indicated time. Set the clock as directed
above.
You may bypass the steps to set the clock. Scanner will function as
normal, but the clock and alarm features will not function. These
features will not be functional until the power is removed and
restored again.
GETTING STARTED
To Next Page
Loading...
Need help?
General
