26
If… Try…
My outgoing message
is gone.
- If there was a power failure, you may
have to re-record your personal outgoing
message.
I can’t hear the base
speaker.
- Making sure call screening is turned on.
- Changing the base speaker volume.
Messages are
incomplete.
- The incoming messages may be too long.
Remind callers to leave a brief message.
- Deleting messages (memory may be full).
When I answer on an
extension, the phone
keeps ringing (or
keeps recording.)
- You may have to change the line mode.
Contact Customer Service for instructions
Weak or Hard To Hear Audio
If a caller’s voice sounds weak or
soft, the signal might be blocked
by large metal objects or walls;
you might also be too far from
the base, or the handset’s battery
may be weak.
x Try moving around while
you’re on a call or moving
closer to the base to see if the
sound gets louder.
x Make sure the handset’s
battery is fully charged.
x Try adjusting the earpiece
volume.
•If you have a hearing aid equipped
with a telecoil (T-coil) feature, the
interaconbetweenthehearingaid
& digital cordless phones can cause
noise in the handset. If you have a T-
coil hearing aid & you have problems
with noise on the line, try turning on
T-coil
mode. Open the menu. Select
Handset Setup,
then select
T-coil
.
•Using T-coil mode can shorten the
handset’stalkme;makesureto
watchthebaerystatusandkeep
thebaerycharged.
To Next Page
Loading...
Need help?
General
