To switch to all capital letters, press
*
.
The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first
letter and wait a few seconds (or press
RIgHT
); the cursor will
move to the next space. Enter the next letter.
Press
#
to enter a blank space.
To change a letter, move the cursor to that letter and press
ClEaR
to erase the letter. Then, enter the new one.
To erase the entire entry, press and hold
ClEaR
.
Press
0
to cycle through all available symbols and punctuation.
USING YOUR PHONE
Basics
To... Handset
make a call Dial the number, then press
Talk/flasH
.
answer a call Press
Talk/flasH
.
hang up Press
End
or put the handset in the cradle.
put a call on hold
Press
HOld/ClEaR/InTERCOM
. After 5 minutes
on hold, the call will be disconnected.
return to a call on hold Press
Talk/flasH
.
mute the ringer for this
call only
While the phone is ringing, press
End
.
To Next Page
Loading...
