What to do if my Uniden HomePatrol - II HomePatrol-II won’t turn on?
If your Uniden Radio HomePatrol-II won’t turn on, hold the Power button down for at least 3 seconds. Ensure the unit is receiving power and that the batteries are correctly inserted. If using a power adapter, verify it's also receiving power.
What to do if Uniden HomePatrol - II HomePatrol-II stops on a channel but I can’t hear anything?
If your Uniden Radio HomePatrol-II stops on a channel but you can’t hear anything, first verify that MUTE is not enabled. Then, check the volume level.
How to fix Uniden Radio HomePatrol-II that won’t stop on any channels?
If your Uniden Radio HomePatrol-II won’t stop on any channels, check for Avoided channels. You may also need to adjust the antenna, range, squelch, or attenuation settings. Try moving the unit to a different location as well.
What to do if weather monitoring won’t work on Uniden Radio?
If weather monitoring isn’t working on your Uniden Radio, it might be due to the absence of a NOAA broadcast in your area. Try adjusting the antenna and squelch settings. Move to an area with a known NOAA broadcast to verify if that's the issue.
Why is recording and replay not working on my Uniden HomePatrol - II?
Recording and replay functions on your Uniden Radio may not work if you are operating from external power only, without batteries installed, or if the battery power is too low. Ensure that you are not operating from external power only, without batteries, and that your battery power is sufficient.
Why won't my Uniden Radio HomePatrol-II turn off?
If your Uniden Radio HomePatrol-II won't turn off, make sure you are holding the Power button down long enough. Press and hold it for at least 3 to 5 seconds.
General safety and usage advice for the scanner.
Information on legal listening and prohibited transmissions.
Overview of key capabilities and system support including trunking and programming.
Guide for running the startup wizard and installing software.
Methods for fine-tuning transmissions: location, service types, range, and lists.
Options for adjusting screen display, audio, and automatic shutoff settings.
Steps for creating and managing Favorites Lists for specific monitoring.
Connecting and configuring an external GPS receiver for location-based scanning.
Setting location formats, baud rates, and GPS input behavior.
To Next Page
General
