28 Additional functions using the PC interface
Changing the Bluetooth name of the handset
The handset is shown by this name on another Bluetooth device.
¤ . . . use to select Bluetooth OK Own Device OK . . . the name and the device
address are shown Change . . . use to change the name Save
Additional functions using the PC interface
QuickSync functions:
• Sync the handset's directory with Microsoft® Outlook®
• Upload CLIP pictures (.bmp) from the computer to the handset
• Upload pictures (.bmp) as screensavers from the computer to the handset
• Upload sounds (ringtone melodies) from the computer to the handset
• Update the firmware
• Cloud synchronization with Google™
¤ Connect the handset to the computer via Bluetooth or via a USB data cableConnect the handset to the
computer via a USB data cable.
Transferring data
¤ Launch the Gigaset QuickSync program on the computer.
The message Data transfer in progress is shown on the display while data is being transferred between
the handset and PC. During this time, it is not possible to enter any data using the keypad and incoming
calls are ignored.
Carrying out a firmware update
¤ Connect the telephone and PC using a USB data cable Launch Gigaset QuickSync Establish the
connection to the handset
¤ Start the firmware update in Gigaset QuickSync . . . Information about this can be found in the Gigaset
QuickSync help
The update process may take up to 10 minutes (not including the download time).
The data is first downloaded from the online update server. The amount of time this takes depends on the
speed of the Internet connection.
The display on your phone is switched off and the Message key and the Talk key start flashing.
Once the update is complete, your phone will automatically restart.
Procedure in the event of an error
If the update procedure fails or the phone does not work properly following the update, repeat the update
procedure:
¤ End the "Gigaset QuickSync" program on the PC Remove the USB data cable from the phone
Remove the battery Reinsert the battery
The Gigaset QuickSync program has been installed on the computer.
The handset is connected to the computer via Bluetooth or via a USB data cable.
Connect the handset directly to the PC, not via a USB hub.
Data transfer using Bluetooth:
• The computer has Bluetooth capability.
• A USB data cable is not plugged in. If a USB data cable is plugged in during an existing Blue-
tooth connection, the Bluetooth connection is interrupted.
Always save own pictures and sounds uploaded onto the handset on the PC also, as they may
be lost during an update.
Do not interrupt the process and do not remove the USB data cable.