Unilumin Upanel 1.2S User Manual

Unilumin Upanel 1.2S Specifications

General

Brand	Unilumin
Model	Upanel 1.2S
Category	Monitor
Language	English

Summary

Critical Safety Warnings

WARNING!

Critical warnings to prevent damage or irreparable harm to the LED display.

Operational Precautions

CAUTION!

Precautions to ensure optimal display performance and prevent equipment failure.

Chapter 1 Product Introduction

1.3 Specification

Technical specifications including pixel composition, size, material, and electrical parameters.

1.4 System Solution

Overview of the LED display system architecture and components.

Chapter 2 Installation and Wiring

2.1 Out-of-Box Inspection

2.2 General Installation

Steps for physically installing the LED display cabinets and modules sequentially.

2.3.2 Signal Cable Connection

2.3.3 Power Cable Connection

2.3.4 Smart Control Distribution Box

Chapter 3 LED Display Control Setting

3.1 Power-on Testing

Pre-operation checks and electrical safety procedures before powering on the display.

3.3 Display Configuration

Steps for configuring display parameters using UniLCT-Mars software.

3.4 Brightness Adjustment

3.5 Correction Coefficient Management

Process for activating and managing color correction coefficients for optimal display.

3.5.1 Setting Coefficients for a New Receiving Card

Step-by-step guide to setting correction coefficients after replacing a receiving card.

3.5.2 Setting Coefficients for a New Module

Guide for setting correction coefficients when a new LED module is installed.

3.6 Pre-storing Picture

Chapter 6 Troubleshooting and Component Replacement

6.1 Common Faults and Troubleshooting Methods

Identification and resolution of common issues with the LED display system.

6.1.1 Failure in Lighting up the Display

6.1.2 Incomplete Picture or Incorrect Position of Picture Displayed

6.1.3 Screen Blinking

6.1.4 Blinking of a Cabinet in the Display

6.1.5 Failure in Lighting up of a Cabinet in the Display

6.1.6 Failure in Lighting up Part of the Modules in the Cabinet

6.2 Replacement of Main Components

Procedures for replacing major components of the LED display.

6.2.1 Replacement of Module

Step-by-step guide for replacing a faulty LED module.

6.2.2 Replacement of Power Supply

Instructions for safely replacing the LED display's power supply unit.

6.2.3 Replacement of Power/Signal Input Cable Switching Board

Steps for replacing the power/signal input cable switching board.

6.2.4 Replacement of Receiving Card

Guide for replacing the LED display's receiving card.