Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
23
TYP This command displays the contents of a le on
the HT630’s LCD. The contents of the le will be
displayed 128 (16 characters x 8 lines) characters
at a time.
Press any key to show the next page or hit
to return to the User Mode Prompt. If you try to display a program
or binary le, you may only see unintelligible characters.
CPY This command allows users to make a copy of data from a source
device to a destination device. The source device may be a le,
COM (serial input), CON (keypad), and the destination device may
be a le, COM (serial output), CON (LCD display).
Source Dest Function
le1 le2 Copy le1 to le2
le1 COM Output content of le1 to serial port
le1 CON Output content of le1 to LCD
COM le2 Input data from serial port and store in le2
CON le2
Input data from keypad and store in le2, press
to end the data input
SET This command allows users to set system date
and time, assign laser features and allow the
display of the power-on logo (see next section).
<TYPE FILE>
SCAN.DAT
<SYSTEM SETUP>
1.DATE
&
TIME
2.SCANNER
3.DISPLAY
4.KEYPAD
5.EXIT
To Next Page
Loading...
