-6- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
Set Data Format
Step 1: Scan DATA FORMAT
Step 2: Scan 1 ~ 3 digits from Full ASCII Table - Numbers
Step 3: Scan DATA FORMAT
Set Field Separator
Step 1: Scan FIELD SEPARATOR
Step 2: Scan one alphanumeric character from Full ASCII Table
Step 3: Scan FIELD SEPARATOR
Set Date/Time
Step 1: Scan SET DATE/TIME
Step 2: Scan 6 digits from Full ASCII Table - Numbers
Step 3: Scan SET DATE/TIMESet
Date/Time Format
Step 1: Scan SET DATE/TIME FORMAT
Step 2: Scan 2 digits from Full ASCII Table - Numbers
Step 3: Scan SET DATE/TIME FORMAT
Note :
1. The scanner will beep three times as indication that a setting is not yet complete or
unexpected barcode is scanned during multi-step configuration.
2. If you make a mistake, forget a step, etc., and want to abort the multi-step configuration,
scan RESET/ABORT and start over again.