Unitech MS842 - Host Serial Response Time-Out; RTS Line State

Host Serial Response Time-out
This parameter specifies how long the digital scanner waits for an ACK, NAK, or
CTS before determining that a transmission error occurred. This only applies when
in one of the ACK/NAK software handshaking modes, or RTS/CTS hardware
handshaking mode.
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code
below to select Low RTS or High RTS line state.
23
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.