Length Within Range - Select this option to decode a Code 93 symbol with a
specific length range. Select lengths using the numeric bar codes in the appendix
of Numeric Bar Codes. For example, to decode Code 93 symbols containing
between 4 and 12 characters, first scan Code 93 – Length Within Range. Then
scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To correct an
error or change the selection, scan the Cancel bar code.
Any Length - Scan this option to decode Code 93 symbols containing any
number of characters within the decoder’s capability.
Code 11
Enable/Disable Code 11
To enable or disable Code 11, scan the appropriate bar code below.
Set Lengths for Code 11
The length of a code refers to the number of characters (i.e., human readable
characters), including check digit(s) the code contains. Set lengths for Code 11 to
any length, one or two discrete lengths, or lengths within a specific range.
One Discrete Length - Select this option to decode only Code 11 symbols
containing a selected length. Select the length using the numeric bar codes in the
appendix of Numeric Bar Codes. For example, to decode only Code 11 symbols
with 14 characters, scan Code 11 – One Discrete Length, and then scan 1
followed by 4. To correct an error or to change the selection, scan the Cancel bar
code.
46
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
To Next Page
Loading...
