Unitech MS852B Plus - Page 115

-99- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.13 EAN/JAN-13
EAN/JAN-13 On*
Default All EAN/JAN
Settings
EAN/JAN-13 Off
3.2.13.1 Convert UPC-A to EAN-13
When UPC-A Converted to EAN-13 is selected, UPC-A bar codes are
converted to 13 digit EAN-13 codes by adding a zero to the front. When Do not
Convert UPC-A is selected, UPC-A codes are read as UPC-A.
Do not Convert UPC-A*
UPC-A Converted to EAN-13
3.2.13.2 EAN/JAN-13 Check Digit
This selection allows you to specify whether the check digit should be
transmitted at the end of the scanned data or not. Default = On.
On*
Off