Unitech MS852B Plus - End of Batch Sending Message; Setting Bar Codes Enable Disable; Scan Mode

-31- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
2.23 End of Batch Sending Message
Note: If ‘Send’ is selected, the scanner will send message “# End of File
Total=Number CS=0xHHHH #” before the end of batch file sending.
Number is total entries in decimal format and 0xHHHH is 32-bit
checksum in hex format.
Send Don’t Send *
2.24 Setting Bar Codes Enable /Disable
Enable * Disable
2.25 Scan mode
Before starting scan mode, please make sure you disable the auto sensing
mode. Scan the bar code below to disable the auto sensing mode
Disable Auto Sensing (Trigger Mode)