Unitech MS852B Plus User Manual

- 107 - © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.16.1 Check Digit
No Check Digit indicates that the scanner reads and transmits bar code data
with or without a check digit. When Check Digit is set to Validate, but Don’t
Transmit, the unit only reads NEC 2 of 5 bar codes printed with a check digit,
but will not transmit the check digit with the scanned data. When Check Digit is
set to Validate and Transmit, the scanner only reads NEC 2 of 5 bar codes
printed with a check digit, and will transmit this digit at the end of the scanned
data. Default = No Check Digit.
No Check Digit*
Validate and Transmit
Validate, but Don’t Transmit
3.2.16.2 NEC 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description for additional information. Minimum and Maximum lengths
= 2-80 Minimum Default = 4, Maximum Default = 80
Minimum Message Length
Maximum Message Length

Unitech MS852B Plus Specifications

General

Brand	Unitech
Model	MS852B Plus
Category	Barcode Reader
Language	English