Unitech MS852B Plus

- 109 - © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.18 Telepen
Telepen On
Default All Telepen Settings
Telepen Off *
3.2.18.1 Telepen Output
Using AIM Telepen Output, the scanner reads symbols with start/stop pattern 1
and decodes them as standard full ASCII (start/stop pattern 1). When Original
Telepen Output is selected, the scanner reads symbols with start/stop pattern
1 and decodes them as compressed numeric with optional full ASCII
(start/stop pattern 2). Default = AIM Telepen Output.
AIM Telepen Output *
Original Telepen Output
3.2.18.2 Telepen Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description for additional information. Minimum and Maximum lengths
= 1-60 Minimum Default = 1, Maximum Default = 60
Minimum Message Length
Maximum Message Length