-114- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.3.7.1 UPC/EAN Version
Scan the UPC/EAN Version On bar code to decode GS1 Composite symbols
that have a U.P.C. or an EAN linear compo-nent. (This does not affect GS1
Composite symbols with a GS1-128 or GS1 linear component.)
Default = UPC/EAN Ver-sion Off.
Note: If you scan coupons that have both UPC and GS1 DataBar codes, you
may wish to scan and output only the data from the GS1 DataBar code.
See Coupon GS1 DataBar Output for further information.
On
Off *
3.3.7.2 GS1 Composite Code Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description for additional information. Minimum and Maximum lengths
= 1-2435. Minimum Default = 1, Maximum Default =2435.
Minimum Message Length
Maximum Message Length
To Next Page
Loading...
Need help?
General
