Unitech MS852B Plus

-72- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
2.32.9 Single Scan Data Format Change
You can also switch between data formats for a single scan. The next bar code
is scanned using an alternate data format, then reverts to the format you have
selected above (either Primary, 1, 2, or 3). For example, you may have set
your device to the data format you saved as Data Format 3. You can switch to
Data Format 1 for a single trigger pull by scanning the Single Scan-Data
Format 1 bar code below. The next bar code that is scanned uses Data Format
1, then reverts back to Data Format 3.
Single Scan-Primary Data Format
Single Scan-Data Format 1
Single Scan-Data Format 2
Single Scan-Data Format 3