Unitech MS852B Plus User Manual

-78- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.2.2 Code 39 Check Characters
No Check Character indicates that the scanner reads and transmits bar code
data with or without a check character.
When Check Character is set to Validate, but Don’t Transmit, the unit only
reads Code 39 bar codes printed with a check character, but will not transmit
the check character with the scanned data.
When Check Character is set to Validate and Transmit, the scanner only
reads Code 39 bar codes printed with a check character, and will transmit this
character at the end of the scanned data. Default = No Check Character.
No Check Character*
Validate , but Don’t Transmit
Validate and Transmit
3.2.2.3 Code 39 Message Length
Scan the bar codes below to change the message length. Refer to Message
Length Description for additional information.
Minimum and Maximum lengths = 0-48.
Minimum Default = 0, Maximum Default = 48.
Minimum Message Length
Maximum Message Length

Unitech MS852B Plus Specifications

General

Brand	Unitech
Model	MS852B Plus
Category	Barcode Reader
Language	English