Unitech PA500 - Connecting the Device to Your Computer

22
Copyright 2007 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Connecting the Device to Your Computer
1. After ActiveSync has been installed, connect the USB charging cable to your device. If
necessary, connect an adapter.
2. Plug the other end of the USB charging cable into a USB port on your computer.
3. Turn the device on.
4. ActiveSync should start automatically and recognize your PA500 and configure the USB port.
The New Partnership setup wizard will automatically start.
NOTE: If ActiveSync doesn’t start automatically, click Start → Programs → Microsoft
ActiveSync.
If a message appears indicating that it is unable to detect a connection, click the
Cancel button and manually configure the communication settings.
5. Follow the onscreen instructions.