Unitron uDirect 3 User Manual

2726
Making phone calls
Use the phone keypad to enter the number and
press the phone dialing button.
When connected, you will hear the dialing tone
through your hearing aids aer approximately
threeseconds.
Using cordless phones (DECT) or older phones
with headset prole only
If your phone only supports the headset
prole (HSP), the connection must be initiated
manually for outgoing calls. This oen applies
to cordless home phones (DECT standard).
For these phones, the audio indicator might not
blink blue even if the phone is paired.
. Dial the number you want to dial on your
phone, or select it from the phone book.
. Briefly press the connect (
) button, then
wait ve seconds.
. The dialing process will automatically start
and the audio indicator will turn solid blue.
You may hear a conrmation beep through
your hearing aids.
Incoming calls
The uDirect  must be switched on, paired to
the phone and worn correctly.
When a call is received on your phone, the
uDirect audio indicator will show a solid blue
light, and you will hear the ringtone signal
through your hearing aids.
Accepting incoming calls
To accept an incoming call, briefly press the
access (
) button on your uDirect  once you
hear the ringtone through your hearing aids.
It will take about ve seconds before you hear
the ringtone through your hearing aids.
“click”
Speak into the uDirect , not into the phone,
when the call is in progress.
For your safety, the hearing aid microphones will
remain on at reduced levels during phone calls
and audio streaming.

Unitron uDirect 3 Specifications

General

Brand	Unitron
Model	uDirect 3
Category	Hearing Aid
Language	English