Unitron uDirect 3 - Testing Sound Via the Udirect 3

1312
will also set the volume level of the spoken
uDirect  messages.
If you cannot hear the sound demo:
• Make sure your hearing aids are inserted
correctly.
• Make sure the uDirect  neckloop is
properly plugged in on both ends and worn
around your neck.
• Make sure the uDirect  is charged and
switched on.
• Make sure you are not on a phone call
connected through the uDirect .
The power indicator is lit as long as you press
a uDirect  button. Green conrms a good
uDirect battery state, red indicates that you
need to charge the uDirect  battery.
Two minutes aer unplugging the neckloop both
indicator lights will switch o and the uDirect 
disconnects Bluetooth to save power.
Testing sound via the uDirect 
. Wear the uDirect  correctly.
. Press and hold the access (
)
button while switching on the device.
Release the access button. The audio
indicator light with turn pink.
The hearing aids will switch to the streaming
mode and you will hear the uDirect  sound
demo.
Use the volume (
) buttons to adjust the
volume.
The sound demo will stop aer three minutes
or when the access button is pressed.
Adjusting the volume during the sound demo