3
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Universal Audio could void the
user's authority to operate the equipment.
Disclaimer
This manual provides general information, preparation for use, installation and operating
instructions for the Universal Audio 2192 Master Digital Audio Interface. The information
contained in this manual is subject to change without notice.
Universal Audio, Inc. makes no warranties of any kind with regard to this manual, or the
product(s) it refers to, including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose. Universal Audio, Inc. shall not be liable for errors contained
herein or direct, indirect, special, incidental, or consequential damages in connection with the
furnishing, performance, or use of this material or the product(s).
Copyright
© 2003 Universal Audio, Incorporated. All rights reserved.
This manual and any associated software, artwork, product designs, and design concepts are
subject to copyright protection. No part of this document may be reproduced, in any form,
without prior written permission of Universal Audio, Inc.
Trademarks
LA-2A, 1176, 2-610, M610, 2108, 6176, 2192, UAD-1, and the Universal Audio, Inc. logo
are trademarks of Universal Audio, Inc. ADAT® is a registered trademark of Alesis Corporation.
Other company and product names mentioned herein are trademarks of their respective
companies.
To Next Page
Loading...
Need help?
General
