43
Index
A
A/D Using External Clock, 29
A/D Using Internal Clock, 28, 30
AC Line, 12
AC Power Input, 16
AC voltage, 26
AD Converters, 25, 26
ADAT, 9, 14, 18, 21, 23, 25, 26
ADAT Audio, 34
ADAT Clock, 33
ADAT In, 26
ADAT Optical, 12
ADAT Optical Digital I/O, 14, 18
ADC input, 10
AES/EBU, 9, 12, 14, 16, 17, 22,
24, 25, 26
AES/EBU Digital I/O, 16–17
AES/SPDIF, 13, 22, 24, 25, 26
AES/SPDIF Switch, 25
Alternate Clock, 37
Analog, 10
Analog I/O, 18–19
Analog In, 25, 26
Analog Line Inputs, 14, 19
Analog Line Outputs, 14, 19
Analog Line Trims, 14, 18, 19
Analog Metering, 21
Analog Outputs DAC Source
Select, 24
Analog Outputs knob, 24
Analog Outputs Source Select, 25
Analog to Digital, 7
Analog to Digital Conversion, 28
B
balanced analog connector, 18
Block Diagram, 15
BNC clock, 22, 27
BNC Clock Inputs, 11
BNC Clock Outputs, 11
BNC Word Clock, 9, 32
C
calibrate, 18
calibrated, 19
calibration, 19
cascading, 8, 17, 27, 28, 30
chassis, 12, 16
Class-A, 7
Clip Indicators, 21
clipping, 19
clock distribution, 8, 27
Clock knob, 21
Clock Source Select, 13, 21
Clock Status, 13, 24
Clocking, 8, 27
CMOS, 17
compatibility, 16
confidence monitoring, 25
Connections, 16, 17
consumer/professional bits, 17
Contents, 4
Controls, 19–26
Conversion, 7, 10
copy-protection, 17
Copyright, 3
D
D/A Using ADAT Clock with
AES/SPDIF Audio, 33
D/A Using AES/SPDIF Clock with
ADAT Audio, 34
D/A Using Digital Audio Source
Clock, 31
D/A Using External BNC Word
Clock, 32
DAC output, 10
daisy-chaining, 8
DC-coupled, 7
Differential shunt attenuation, 19
Digital, 12
Digital Audio Clock, 36
Digital Audio Workstation, 40
digital clipping, 19
Digital I/O, 16–18
Digital Outputs Source Select, 25
Digital to Analog, 7
Digital to Analog Conversion, 30
dimensions, 12
Dual Wire Mode, 16
dual-differential, 7, 9
Dynamic range, 10
Dynamic Range: A/D, 39
Dynamic Range: D/A, 39
E
external clock, 7, 23
external clock master, 37
F
factory calibration, 19
FCC Compliance, 3
Features, 9
Frequency Response, 10, 38
Front Panel, 13
full scale code, 21
G
Ground Isolation Jumpers, 20
H
Headroom, 10, 19
high resolution, 18
I
IEC power cable, 16
imbedded, 31
impedance, 19
Index, 42
Input Level Meters, 13, 21
Inputs, 10
Internal, 22, 24
internal clock, 27, 35
Introduction, 7
isolate, 18
J
jitter, 8, 9
jumper block, 18, 20
L
LED display, 21
Level Meters, 21
Level Trim, 10
Line Input Trims, 19
Line Output Trims, 19
Line Trim Procedure, 19
List of Figures, 6
List of Tables, 6
Lo-Z, 10
M
master clock frequency, 23
master clock source, 8
Mastering Setup, 40
matched-FET, 7
Max input, 10
Max output, 10
maximum levels, 19
Metering, 21
Min input, 10
Min output, 10
multiplexing, 18
To Next Page
Loading...
Need help?
General
