11
SEARCHING FOR YOUR CODE
If your home entertainment device does not respond to
the Atlas Universal Remote Control after trying all of the
codes listed for your brand, or if your brand is not listed
at all,try searching for your code.
NOTE: To search for a code in the CBL mode, you’ll first need to
unlock the cable ID Lock – see “Programming ID Lock” on
page 13.
For example, to search for a code for your TV:
1. Turn on your TV.
2. On the remote control, press TV once.
Then press and hold SETUP until the
TV key blinks twice, then release SETUP.
3. Enter 9 - 9 - 1.The TV key will blink twice.
4. Aim the remote control at the the TV and slowly
alternate between pressing POWER and TV.
Stop when the TV turns off.
NOTE: In the search mode, the remote control will
send IR codes from its library to the selected
device, starting with the most popular code first.
5. Press SETUP once to lock in the code. The TV
key will blink twice.
6. To search for the codes of your other devices,
repeat steps 1 through 5,but substitute the
appropriate key (i.e.,AUD,VCR,or CBL) for
the (Audio,VCR, or Cable) device you are
searching for.
To Next Page
Loading...
