12
CHECKING THE CODES
If you have set up the Atlas Universal Remote Control
using the Searching For Your Code procedure (on the
previous page), you may need to find out which four-digit
code is operating your equipment.For example,to find
out which code is operating your TV:
1. On the remote control, press TV once.
Then press and hold SETUP until the
TV key blinks twice, then release SETUP.
2. Enter 9 - 9 - 0.The TV key will blink twice.
3. To view the code for the first digit,press 1 once.
Wait 3 seconds and count the number of times
the TV key blinks (e.g., 3 blinks = 3) and write
down the number in the leftmost TV Code box
(see below).
NOTE: If a code digit is ā0ā, the selected mode key will
not blink.
4. Repeat step 3 three more times for remaining
digits. Use 2 for the second digit, 3 for the third
digit, and 4 for the fourth digit. Finish writing
down the code in the TV Code boxes below.
5. To check for other device codes,repeat steps 1
through 4,but substitute the appropriate key
(i.e., AUD,VCR,or CBL) for the (Audio,VCR, or
Cable) device you are checking.Write down the
codes in the appropriate boxes below.
AUD
Audio Device ____________________
VCR
TV
CBL
To Next Page
Loading...
