Link to Table of Contents
User Guide
22
Glossary of Terms
Y-Axis – The front to back direction in the Main Enclosure. Also, the mechanical system used to move the X-Axis Arm front
to back in the enclosure.
Y-Axis Bearings – The bearings on the ends of the X-Axis Arm that guide it along the Y-rails.
Y-Rails – The two parallel rails that guide the X-Arm front and back inside the Main Enclosure.
Z-Axis – The up and down direction in the Main Enclosure. Also, the mechanical system used to raise and lower the
table on which the work piece is placed.
To Next Page
Loading...
