Universal Remote PowerPak RF-20 - Re-Setting RF20 to Original Factory Default Settings

39 40
Re-setting RF20 to Original
Factory Default Settings
ERASING COMMANDS
ERASING COMMANDS
Re-setting RF20 to Original Factory Default Settings
STOP
BUTTON
MAIN
BUTTON
SURE
BUTTON
STEP 1:
Press and hold both the
MAIN and the STOP buttons
for 10 seconds.
STEP 2:
After 10 seconds, the RESET
screen appears. Press the ALL
button. The RF20 will display a
“SURE?” button. Press the
SURE button to erase all of your
settings and return to the factory
default setup
Re-setting RF20 to Original
Factory Default Settings
If you want to start with a clean slate, you can re-set the
RF20 its original factory default settings by performing the
following steps.
NOTE: This process will essentially erase EVERYTHING
you have programmed into the RF20.