Need help?Do you have a question about the Universal Remote URC-R6 and is the answer not in the manual?
General| Brand | Universal Remote |
|---|---|
| Model | URC-R6 |
| Category | Remote Control |
| Language | English |
The AVEX R6 remote controls up to six audio/video components from various brands.
Press a component button to operate that specific device; the LED indicates the active component.
Insert two AAA batteries, matching positive and negative terminals, into the compartment.
The component LED blinks three times when the Power button is pressed if batteries are low.
The remote automatically turns off if a button is pressed for over 30 seconds to save battery.
Turn on the component, then press and hold the component button while pressing numeric keys until the component turns off.
Enter a 3-digit code from the manual using the number pad, then test the component's function.
Scan through codes using UP/DOWN arrows until the component turns off, then save the code.
Store up to 20 commands on Macro buttons (POWER, SYSTEM OFF, A, B, C, D) for one-button operation.
Program POWER or SYSTEM OFF buttons to control multiple devices simultaneously.
Details on programming delays, layers, and limitations for macro commands.
Program the A, B, C, D buttons to access favorite channels with a single press.
Program up to 5 favorite channels per button or record custom macros for channel switching.
Allows channel control buttons to operate in other component modes.
Enables VCR/DVD transport controls to function in other component modes.
Allows OSD and cursor controls to operate in other component modes.
Erase a specific learned command from a component.
Erase all learned commands for a specific component.
Erase MacroPower commands from POWER ON or SYSTEM OFF buttons.
Erase SimpleSound or other 'Punch Through' commands.
Lists setup codes for Cable Set-top boxes and Satellite receivers.
Lists setup codes for TVs, Plasmas, Projectors, and Monitors.
Lists setup codes for VCRs, DVRs, and Combo Units.
Lists setup codes for DVD Players and Recorders.
Lists setup codes for Amplifiers, Preamps, and A/V Receivers.
Lists setup codes for iPod, Media PC, Gaming Systems, and Lighting Controls.
Settings are stored in non-volatile memory and retained when batteries are removed.
MacroPower allows multiple device commands to be executed with a single button press.
Replace batteries if the remote no longer works from a distance.
Contact Universal Remote Control support via email, website, or phone for assistance.
To Next Page
