Page 23
OSD (On-Screen Display) Control “Punch
Through”
This “Punch Through” enables you to program the
AVEX R6 so that CBL or DVD OSD Controls
(MENU, GUIDE, INFO, EXIT, SEL and 4 Cursor
Controls) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button you
want to add OSD Control to, such as TV or VCR,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the MENU button. The component
LED will blink once.
STEP 3: Press either the CBL or DVD button that
you want to use as the source of OSD Control. The
component LED will blink three times to confirm it is
saved.
COMPONENT
BUTTONS
SELECT
MENU
To Next Page
Loading...
Need help?
General
