10
The Unifier
Press and hold the same button on your old remote
control once again.
The Unifier’s unique DoubleTap learning technology
ensures compatibility with the widest variety of remote
controls ever!
Once you have taught the button twice, the display
will change to either “GOOD” or “FAILED”.
If the “GOOD” label appears on top of the display
and “SAVED” flashes on the bottom, you were
successful. Now, press the next button you wish to
teach (repeating steps 3 through 6 until you have
learned all the buttons you want).
If the “FAILED” label appears on top of the display,
try to teach the same button in Unifier once again
by repeating steps 3-6.
Once you completed teaching all the buttons, save
your work and return to normal operation by
pressing the LIGHT button. Test all your new
commands. If any of them don’t work, try learning
again using these notes:
Move to another room. Plasma TVs, sunlight, halogen or
quartz lighting can interfere with the learning process.
Although the old remote control seems to work fine,
change the batteries to fresh alkaline batteries.
Vary the distance between the remote controls
gradually. Try 1/4”, 1”, 2”and so on, up to 4 feet.
Tap the button on the original remote control instead of
pressing and holding it during the learning process.
7
5
6
To Next Page
Loading...
Need help?
General
