6.Transportation
Only transport the robot in its original packaging. Save the packaging material in a dry place if you
want to move the robot later.
When moving the robot from its packaging to the installation space, hold both tubes of the robot
arm at the same time. Hold the robot in place until all mounting bolts are securely tightened at the
base of the robot.
Lift the Control Box by its handle.
WARNING
1. Make sure not to overload your back or other bodyparts when lifting the
equipment. Use proper lifting equipment. All regional and national lifting
guidelines shall be followed. Universal Robots cannot be held responsible for
any damage caused by transportation of the equipment.
2. Make sure to mount the robot according to the instructions in
chapterMechanical Interface.
NOTICE
If the robot is attached to 3rd-party application / installation during transport,
please refer to the following:
Transporting the robot without its original packaging will void all warranties from
UniversalRobotsA/S.
If the robot is transported attached to a 3rd-party application / installation, please
see the recommendations for transporting the robot without the original transport
packaging.
You can see the recommendations for transportation without packaging on help.universal-
robots.com/
6.1. Transport Without Packaging
UniversalRobots always recommends transporting the robot in its original packaging.
These recommendations are written to reduce unwanted vibrations in joints and brake systems
and reduce joint rotation.
If the robot is transported without its original packaging, then please refer to the following
guidelines:
Hardware Manual 59 UR5e
6.Transportation
Copyright © 2009–2022 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
