SRM60+/ SRM80+ TROUBLESHOOTING GUIDE (CONTINUED)
7. Attachments contact
side of bowl
7.1 Dented bowl.
7.2 Insufficient clearance
between bottom of bowl
and beater.
7.1 Remove dents or replace bowl.
7.2 Adjust bowl height.
8. Excessive noise 8.1 Gears need to be repacked
with grease.
8.2 Badly worn or frayed drive
belts.
8.3 Attachments hitting bowl.
8.4 Overloaded mixing bowl.
8.5 Defective bearings
8.1 Locate source by inspection
and repack with grease.
8.2 Replace belts.
8.3 Inspect for cause in items
6 & 7 above.
8.4 Adjust contents of bowl
8.5 Locate the defective bearings
and replace the assembly
Page 1.2
To Next Page
Loading...
