start
USB key
UNOXDIR
USB key
Trash
HD
FIRMWARE
ON
UNOXDIR
1057.bin
FIRMWARE
PLUS ONE
1057_F.bin
FIRMWARE
1058.bin
1058_F.bin
BIG / L Series
FIRMWARE
1062.bin
1062_F.bin
start
USB key
UNOXDIR
USB key
Trash
HD
FIRMWARE
UNOXDIR
1057_F.bin
FIRMWARE
PLUS ONE
1057.bin
FIRMWARE
1058_F.bin
1058.bin
BIG / L Series
FIRMWARE
1062_F.bin
1062.bin
NEW!
4.4
4
5
8
start
start
USB key
Trash
HD
Trash
HD
xxxxx.zip
UNOX
DOWNLOAD
start
Trash
HD
zip
clik
clik
UNOXDIR
USB key
UNOXDIR
UNOX
4
Forced upgrade procedure
If the regular upgrade procdure does not
work and when you have to replace the
control panel and recover the original SD
card, proceed as follows:
Make sure you have the latest
software available saved in the folder
“FIRMWARE” of your USB stick.
Rename the software:
from 1057.bin -> to 1057_F.bin
(KPE1057)
from 1058.bin -> to 1058_F.bin
(KPE1058)
from 1062.bin -> to 1062_F.bin
(KPE1062)
If you are replacing the control board
follow steps “3” and “4” otherwise skip to
step “5”.
Remove the SD card from OLD
panel.
4
Insert this SD card inside the NEW
control panel.
6
Turn on the oven and wait until the
forced upgrade is complete.
Unzip the folder just saved on your
desktop.
5 PLUG the USB stick with the
renamed file and then SWITCH ON
the oven by pressing the power button.
7 Upgrade the parameters of the
model with the standard procedure
above starting at section “Load the
parameter file procedure”.
8 After the forced upgrade the oven
will automatically change the name
of the software file to 1057_.bin,
1058_.bin or 1062_.bin.
Therefore rename the file if you intend
to use the file in regular procedure:
from 1057_.bin -> to 1057.bin (KPE1057A)
from 1058_.bin -> to 1058.bin (KPE1058A)
from 1062_.bin -> to 1062.bin (KPE1062A)
4 Open the USB stick, copy the
UNOXDIR folder from the unzipped
file and paste it in the USB.
To Next Page
Loading...
Need help?
General
