UPM THM301A - Required Installation Tools

9
- AA SIZE +
- AA SIZE +
Two AA size batteries (included)
Wire Stripper/Cutter
(If necessary, to strip the wires)
Level
(If necessary, to level the thermostat)
Masking Tape
(To wrap the exposed wires temporarily and labeling
the disconnected wires)
Hand Power Drill with a 3/16 inch bit
( If necessary, to drill holes on the wall )
Cross screwdriver
The following tools may be required for installation:
See below to select a suitable place for the new thermostat installation. And refer to Replacing Old
Thermostat section to replace old thermostat.