UPRtek PG200N User Manual

23
Uses connuous measurement to measure the various values
and saves them automacally in Excel format.
Set up operaon condions
Press the “ ” seng buon at the boom of the screen to
set the Integraon mode, Integraon me, interval and counts
in order; press the “ ” buon at the boom of the screen
when completed to return to the measurement screen and
start performing measurement.
3.6 LOGGING Mode
1
3
2
Exposure mode can
have exposure me set
up in manual mode only.
The range of measurement
interval is 00 (hour):00
(minute):10 (seconds)
~23:59:59.
The range of connuous
measurement count is:
1~9999999 mes.
■
Integraon mode
■
Integraon me
■
Interval
■
Counts
4
Seng complete; return to the
measurement screen.
24
3.6 LOGGING Mode
Measurement
Point opcal sensor to light source
to be tested.
1
2
3
The Count opon will reset to its
default sengs aer measurement
is done.
4
Icon at the upper right corner
spins continuously in case the
continuous measurement is in
progress.
The count field displays
balance of measurements.
This means that the
connuous measurement
has started.
To stop connuous measurement
in between, please press the“ ”
stop buon.
Press the measurement buon at boom center of screen or the
measurement key at le hand side to measure. (You can press
measurement key at both sides.)

UPRtek PG200N Specifications

General

Brand	UPRtek
Model	PG200N
Category	Measuring Instruments
Language	English