UPRtek PG200N - Measurement Settings: Operational and Calibration

37
4.1 Measurement Settings
■
Capture funcon
Select for one me or connuous
measurement. In case connuous
measurement is set, press
Measurement/ Local Measurement
key to start auto measurement
at frequency of once per 3
seconds. Press Measurement/
Local Measurement key again
to stop connuous measurement.
(See Secon 4.2: Connuous
measurement for reference.)
■
Integraon mode
■
Integraon me
Select auto or manual mode.
Exposure me need be set in
case manual mode is chosen.
Exposure me may set in unit
of microsecond (0.001 second).
Valid range:100us~1000ms
The seng interval is ± 0.1ms for 1ms or less
The seng interval is ± 1ms for 1~10ms
The seng interval is ± 10ms for10~100ms
The seng interval is ± 100ms for 100ms or above.
＋
/
－：
Adjust key
■
Operaon sound
■
Reference spectrum
■
Auto shuer
Select to on/off operaon
sound. Set operaon sound
on to beep once aer
measurement operaon
(enabled by pressing the
Measurement / Local
Measurement key) completed.
This funcon will only be
displayed under PPFD
SPECTRUM mode.
When users press the
measure buon on the
screen/on the machine,
dark calibraon will be
executed before the
measurement.
38
4.1 Measurement Settings
1.
Please use PG200N Thermal-Hygro cable along with PG200N for
temperature and relave humidity measurements.
■
Dark calibraon
■
Temperature offset
■
Humidity offset
This product is default to
run background calibraon
aer power on. This operaon
enables running background
calibraon any me.
The range of temperature
offset is -5°C ~ +5°C.
The range of relave humidity
is -5%RH ~ +5%RH.