urmet domus STUDIO 2 plus - Pause and Dialing Mode Settings; Restart to Factory Default; Operation; Telephone Operations

18
DS4057-001C
The fi rst digit of the three will fl ash. Press to select the digit and press
to confi rm . Use the same method to continue setting each code prefi x code is
used for adding specifi c number (ie. 0 or 9) in front of dialing numbers of caller ID, and
predial,especially used behind PABX.
6. Set the Ring Melodies
After set up the PREFIX CODE, press to access the RINGER MELODY setup.
Press to select the music(1-16) and press to confi rm.
7. Set the Ring Volume
After set up the RINGER MELODY, press
to access the RINGER VOL. setup. Press
to select the ring volume (1-4) and press to confi rm.
8. Set Flash Time (This setting for using behind of PABX only)
After set up the RINGER VOL., press to enter the FLASH TIME setup. Press
to select the fl ash time (100ms, 200ms, 300ms, 400ms,600ms, 900ms) and
press to confi rm.
9. Set Pause Time
After set up the FLASH TIME, press to enter the Pause Time set up. Press
to select the PAUSE TIME (1.2 sec, 2.4 sec, 3.6 sec, default is 2.4 sec) and
press to confi rm.
10. Set DTMF or Pulse Mode (Default in DTMF, No need to set if it meet telecom dialing
mode)
After set up the PAUSE TIME, press to access the DIAL IN DTMF or DIAL IN
PULSE setup. Press to select the mode (DTMF or PULSE) and press
to confi rm.
11. Set T1,T2, T3
After set up DIAL IN DTMF or DIAL IN PULSE, press to access T1 ,T2,T3 set up.
This function is set for specifi c PABX. Users can ignore this function.
12. Restart to factory default setting
Warning: Press and hold the key / for 8 seconds, will restart the phone set to
factory default setting and all Caller ID, speed dial memories wllI be cleared.
OPERATION
A. TELEPHONE
1. Make a Call:
Pick up the handset or press to get dial tone and dial the number. When the called
party answers the phone,the LCD will time the call automatically.
2. Pre-dial:
In on-hook status, dial the phone number and press or pick up the handset. The
number will be dialed automatically.
3. Answer the Call:
Pick up the handset or press to answer the call.
4. End a Call: