Page 14
LPX SEED TREATER
SAFETY LABELS
1. Keep safety labels clean and legible at all times.
2. Replace safety labels that are missing or have become illegible.
3. Replaced parts that displayed a safety sign should also display the current sign.
4. Replacement safety labels are available. Contact USC at (785) 431-7900 .
How to Install Safety Labels:
Be sure that the installation area is clean and dry.
Be sure temperature is above 50
o
F (10
o
C).
Decide on the exact position before you remove the backing paper.
Remove the smallest portion of the split backing paper.
Align the sign over the specified area and carefully press the small portion with
the exposed sticky backing in place.
Slowly peel back the remaining paper and carefully smooth the remaining
portion of the sign in place.
Small air pockets can be pierced with a pin and smoothed out using the piece
of sign backing paper.
Located on the USC equipment you will find safety labels.
Always be sure to read and follow all directions on the labels.
Situé sur l'équipement USC vous trouverez des étiquettes
de sécurité. Veillez à toujours lire et suivre toutes les
instructions sur les étiquettes.
! AVERTISSEMENT
Guards provided with USC equipment are to remain in place
during operation.
Gardes fournis avec des équipements USC doivent rester
en place pendant le fonctionnement.
! AVERTISSEMENT
To Next Page
