Page 21
LPX SEED TREATER
Flexible conduit is recommended
for main power supply.
LPX MANUAL TREATER SET - UP
13. Have a certified electrician provide power to the seed treating system. Provide
convenient shutdown switches, comply with local electrical codes and ensure that
the system is properly grounded and bonded.
All USC control panels must be connected adhering
to the same electrical requirements as specified in
the main control panel on the power requirement tag
(right), or the electrical schematic shipped with the
piece of equipment. This will power the USC LPX
Manual seed treater and any attached conveyors.
14. Provide 110V single phase power to both the
treater control panel and the pump stand(s).
15. Reverse the previous steps when removing the
machine from its working position.
Incoming power connected to
these terminals in the Treater
Control Panel
NOTICE
AVIS
Conduit flexible est recommandé pour
l'alimentation principale.
To Next Page
