Page 52
LPX SEED TREATER
Problem Possible Cause Solution
Pump is fluctuating. 1. Restriction in tubing
2. Filter is plugged or missing
gasket.
1. Flush tubing and check filter
for any restrictions.
2. Clean filter and check for
gasket.
Seed calibration is fluctuating. 1. Seed treater supply hopper is
not staying full.
2. Restriction in the supply
hopper or seed wheel.
3. Build-up in the atomizing
chamber.
1. Make sure the supply hopper
and seed wheel are staying
full. May have to lower seed
flow rate in order to have a
consistent flow of seed.
2. Check supply hopper and
seed wheel for any debris,
and remove.
3. Remove atomizing housing
and clean out any build-up
of material.
Drum is slipping and seed is
coming out the inlet side of the
drum.
1. Drum is wet.
2. The seed treater is set too
level.
3. Chains are too loose.
1. Dry off any moisture that may
have collected on the outside
of the drum.
2. Adjust the slope of the seed
treater to at least a 3” drop
from front to back. If desired,
more slope can be applied.
3. Check and tighten the drive
chains. Also check the chain
alignment.
None of the motors will turn to
ON in HAND mode.
1. Processor is faulted.
2. Emergency Stop button is
activated.
3. The Emergency Stop RESET
button has not been pressed
after the Emergency Stop
button has been pulled out.
1. Disconnect power and wait
30 seconds before
reconnecting power.
2. Pull out the Emergency Stop
button.
3. After the Emergency Stop
button has been pulled out,
press the Emergency Stop
RESET button.
E-stop is flashing. 1. An E-stop may be
depressed.
2. Power may not be on to the
control panels.
3. One of the control panels
may not be connected to all
of the others.
1. Ensure all E-stops are not
depressed.
2. Check incoming power to
each control panel.
3. Check the wiring and
connections to each
control panel.
To Next Page
