After changing the setting, restart the network or turn the machine OFF and then ON.
Item Description
IPSec Make this setting when you use IPSec.
*1
Value: Off, On
*1 The setting will be changed after restarting the device or the network for the machine.
Item Description
SSL Select whether or not to use SSL.
Value: Off, On
IPP Security Select the IPP security level. This setup is available when SSL is [On].
Value: IPP/IPP over SSL, IPPoverSSL only
HTTP Security Select the HTTP security level. This setup is available when SSL is [On].
Value: HTTP/HTTPS, HTTPS Only
LDAP Security (Ext. Address
Book)
Select the type of encryption according to the type of security employed by the LDAP server.
This setup is available when SSL is [On].
*1
Value: Off, SSL/TLS, STARTTLS
*1 LDAP must be set to [On] in Protocol Detail on page 8-29.
LDAP Security (User Property)
SMTP Security Select the communication protocol according to the type of security employed by the SMTP
server. This setup is available when SSL is [On].
Value: Off, SSL/TLS, STARTTLS
POP3 Security (User 1) Select the communication protocol according to the type of security employed by the POP3
server. This setup is available when POP3 is [On].
Value: Off, SSL/TLS, STARTTLS
POP3 Security (User 2)
POP3 Security (User 3)
Item Description
LAN Interface Specify the settings for the LAN interface to be used.
Value: Auto, 10Base-Half, 10Base-Full, 100Base-Half, 100Base-Full, 1000BASE-T
To Next Page
Loading...
