Floor Screed Machine HD 50 4
www.utiform.com departamento.técnico@utiform.com Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
1 About this manual
This instruction manual is divided into the following main chapters and deals with the two main units: the
machine and the motor compressor.
• Instructions
• Safety indications
• Technical specifications
• Maintenance
Safety precautions are indicated at the start of every section and /or contained in tables.
These handling and maintenance instructions should always be available in the workplace. All the
instructions should be read, understood and carried out prior to starting the machine.
2 Basic safety instructions
This manual contains the main guidelines for handling the HD-50/07 machine with total safety. Very important
points are indicated with a special symbol. These mean:
WARNING: This symbol means that there is direct risk to life and health due to
mechanical effects.
WARNING: This symbol means that there is direct risk to life and health due to electrical power.
WARNING: Maintenance and service work BE CAREFUL!
2.1 Obligations
The instruction manual should always be kept nearby the machine. In addition to the manual, the local
regulations on accident prevention and environmental protection should also be on hand and consulted.
In addition the regulations of the country where the machine is to be used should be taken into account.
All the safety and hazard indications on the machine should be
legible and should be renewed when required.
This Floor Screed Machine should only be used:
• in accordance with the terms for use
• in technically safe and adequate conditions
Breakdowns which affect safety of the machine or persons handling it should be resolved immediately.
To Next Page
Loading...