7
NEW CONSTRUCTION INSTALLATION INSTRUCTIONS (Continued)
7. Join the connectors for the LED light from the fan
housing (A) to the grille (B). The grille (B) must be
connected before turning on power to the fan.
A
B
7
8. Attach grille (B) by pinching the mounting springs and
inserting them into the narrow rectangular slots in the
fan housing (A).
Turn on power source. Test the unit.
A
B
8
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS
Installing the fan housing (A) in an existing building requires
an accessible area (attic or crawl space) above the planned
installation location, as well as existing duct and wiring.
BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK! Ensure the
electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker
before removing the existing bath fan or installing the
new one.
To Next Page
Loading...
