1 Introduction
Thank you for purchasing our CryptoServer LAN V4 security system (referred to below also as
CryptoServer LAN). We hope you are satisfied with our product. Please do not hesitate to
contact us if you have any questions or comments.
1.1 About This Manual
In this operating manual you will find all the necessary information for using the hardware of
the CryptoServer LAN as well as essential security instructions that are to be followed in order
to ensure that the device can be operated safely.
1.1.1 Target Audience for This Manual
This manual is intended for system administrators who bring the CryptoServer LAN with an
integrated CryptoServer CSe- or Se-Series Gen2 into service and administer it.
1.1.2 Contents of This Manual
After the introduction this manual is divided up as follows:
Chapter 2 provides safety instructions that should be read carefully, before unpacking the
CryptoServer LAN and bringing it into operation.
Chapter 3 shows the different ports, interfaces and operating elements on the front and rear
side of the CryptoServer LAN, and provides a general description of the procedure for bringing
the CryptoServer LAN into service.
Chapter4 contains the maintenance tasks that a customer is permitted to perform on the
CryptoServer LAN, i.e., to check the power level of the batteries (carrier battery and external
battery) and, if necessary, to change the external battery in the battery compartment, as well
as to remove/swap a power supply module.
Chapter 5 provides instructions on how to switch off the CryptoServer LAN.
Chapter 6 gives information about what needs to be taken into account when disposing of the
CryptoServer LAN.
Chapter 7 is an overview of the essential technical data of the CryptoServer LAN with AC
power supply.
Chapter 8 is an overview of the essential technical data of the CryptoServer LAN with DC
power supply.
To Next Page
Loading...