14
UWATEC
®
Smart dive computer
4 Setting up Smart Z
How to check if transmitter and computer are paired correctly:
1. Switch on the computer manually (B and E)
2. Move the computer into transmitting range of the transmitter.
3. Open the tank valve. The transmitter switches on automatically.
4. Check the display: Pairing has been carried out correctly if the pressure is
displayed within 5-10 seconds.
If the transmitter has been correctly paired, but Smart Z cannot receive the tank
pressure, "- - -" will appear on the display. In that case, check the position of
transmitter and dive computer.
If
the transmitter has not been paired, or if an existing pairing has been
deleted via SmartTRAK, the display will remain empty.
In that case, transmitter and computer must be paired again.
Pairing ok
P
airing not present
To Next Page
Loading...
Need help?
General
