UWE APM - Instruction for Use

5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a. Connect the load cell signal and power to the
indicator properly.
b. Place the scale on a level and strong surface.
c. The indicator is turned on.
d. The ZERO INDICATOR is on. If not, press ZERO to set
display to zero.
5.2 WEIGHING
a. Always place an object onto the scale gently.
Excessive force applied to platter may cause damages
to weight sensor.
b. The weight of the object is displayed on the indicator
automatically.
c. It is a good practice to remove all loads from scale
after weighing. It would prolong the lifetime of
weight sensor.
5.3 SELECT WEIGHT UNIT
Press MODE to shift among kg  decimal  lb/oz.  kg
weight units. Refer to 4.2.1 for internal setting
procedures.