4. INITIAL SETUP
4.1 PLACING THE SCALE
In order to obtain an accurate weighing result, the
complete weighing instrument (hereinafter referred as
the scale) must be placed on a strong and level surface.
4.2 INTERNAL SETTING
4.2.1 Display Segment Check
User can enter this function to check and see if the
display and backlight (if purchased) are functioning
properly.
a. Scale is off
b. Press and hold TARE, then press ON/ZERO
c. Scale displays F1
d. Press TARE once to F2
e. Press MODE and all segments will light up to allow
user to check the condition of display
f. Press any key to exit (scale displays P=00 that can
be ignored.) and press TARE for next function setup
or ON/ZERO to restart the scale
4.2.2 Select Auto Power Off Setting
The scale is equipped with Auto Power Off Function. The
scale will power off automatically if it is not used
To Next Page
Loading...
