5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a. Connect the load cell signal and power to the
indicator properly
b. Place the scale on a level and strong surface
c. The scale is turned on
d. The ZERO INDICATOR is on. If not, press ON/ZERO to
set display to zero
5.2 WEIGHING
a. Always place an object onto the scale gently
Excessive force applied to platter may cause damages
to weight sensor
b. The weight of the object is displayed on the indicator
automatically
c. It is a good practice to remove all loads from scale
after weighing. It would prolong the lifetime of
weight sensor
5.3 SELECT WEIGHT UNIT
Press MODE to shift between metric or avoirdupois weight
units. The weight unit used before power off would be
employed when the scale is turned on again.
To Next Page
Loading...
